I have a camp that I am restoring but I need dark green metal roof paint to complete the transformation as the metal roof is not in dissary to compliment the cedar siding..All replies thank you very much.
I was having trouble adjusting a photo inside a hinged mat since it was cut with very little room for error, so my teacher handed me two metal clips. They are placed on either side of the photo, you close the mat and adjust the photo, then when you open it to place photo corners the picture doesn’t move. I asked my teacher what they were called or where they were sold and he had no idea, he’d bought them when he was in college from some catalog.
The paint is flaking and peeling off the metal pipe. The pipe is rusty. It is the source for heat so convering it up is not a solution. This will be the first time I am trying to DIY. So please be specific and detailed on how it should be done right. Thanks.
I have to screw in the tabs from an air conditioner into a metal window frame. This probably doesnt seem hard to most people, but I am not a hany person. How would i go about doing this without killing myself?
One of the questions on my Chem. homework asked me to explain why a metal collaspes when air is pumped out of it with a vacuum tube in terms of a kinetic-molecular model.
Help is greatly appreciated.
I want to know what kind of metal bats Japanese people use. Any manufacturers, any sporting goods stores that have a web site, any contacts or websites that could push me in the right directions. Thanks.
We know that metal expands when heated, so what will happen if you cut a hole the size of a quarter in the center of a cookie sheet, then pop it in the oven until it’s very hot? Will a quarter still fit in the hole? Will the hole be bigger or small and why?
Thanks!
I recently bought a gas dryer. After hooking up the exaust, I read in the manual… “do not install flexible metal vent in enclosed walls, ceilings or floors.” Does this mean I cant run the flexible metal vent that I have directly through a wall, which is no more than 6 inches in length? OR does it mean not to run the vent from the bottom of the wall to the top?
I have removed my metal garage door, and my heater and I need a service to come to my home to collect and remove it. What are these services called? and does anyone know were i can find one in Melbourne?
you know, pantera had their original heavy guitar riffs which made groove metal (basically), Korn made Nu-metal (which most of it sucks), and The big four of Thrash Made well, Thrash metal
one day, i want to be in a famous metal band and maybe start a new metal genre.
so what could i do to be original?
i thought of making a death metal Harmonica, what are all your ideas?